Small hydraulic pump 25A Electric hydraulic pump Ultra-high pressure hydraulic electric pump
Function DescriptionFunction:
The hydraulic electric pump has the functions of small size, high pressure, light weight, easy to carry, easy to operate, and widely used;
High and low pressure two-stage output, large oil volume;
The low pressure adopts the plunger type to increase the effective pressure;
Single oil circuit, electromagnetic wired remote control, suitable for various functions such as cutting, perforating, bending, lifting, etc.;
Pressure overload protection device to avoid damage to equipment caused by overpressure;
Automatic protection to ensure that it will not be leaked during use;
Equipped with a pressure switch, the oil pump can be controlled to stop working when the pressure is in place.
Weight: 13KG
$668.00
Compare
| Voltage: 220V | Motor power: 600W |
| Frequency: 50Hz | Speed: 1400r/min |
| High pressure: 70Mpa | High pressure flow: 0.6L/min |
| Low pressure: 7Mpa | Low pressure flow: 3.5L/min |
| Oil storage capacity: 4L | Outer box size: length 170X width 230X height 370mm |
| Oil type: 32# or less anti-wear hydraulic oil or 7-15# hydraulic transmission oil | |
| Weight: 13KG |
Based on 0 reviews
Be the first to review “Small hydraulic pump 25A Electric hydraulic pump Ultra-high pressure hydraulic electric pump”
Related products
-
Hydraulic Pumps, Hydraulics
Vane pump 45V-60A-1C-22R machine tool engineering machinery high pressure master hydraulic vane pump
Hydraulic Pumps, HydraulicsVane pump 45V-60A-1C-22R machine tool engineering machinery high pressure master hydraulic vane pump
pump start
1. Before starting the oil pump, check the inlet and steering, and do not make mistakes in the direction.
2. Fill the pump with oil for the first start, and turn the coupling by hand. The rotation force should feel even and flexible.
3. When the machine is started for the first time or after a long-term shutdown, it will cause air suction. Therefore, an exhaust valve should be installed at the output port, or the outlet flange should be slightly loosened to remove air, and a test run should be carried out under no-load conditions as much as possible.SKU: n/a -
Hydraulics, Hydraulic Pumps
Manual pressure test pump 40kg,60kg coal to electricity coal to gas PPR water pipe leak detector
Hydraulics, Hydraulic PumpsManual pressure test pump 40kg,60kg coal to electricity coal to gas PPR water pipe leak detector
Failure Causes and Solutions
(1) When the handle moves upward, the water cannot be sucked up 1. Check whether the suction pipe is blocked by garbage 2. Check whether the switch is tightened
(2) Weakness when the handle moves up and down 1. Check whether the switch is tightened
2. Check whether the sealing ring of the piston shaft is damaged. 3. Check whether the one-way valve in the water outlet joint is dirty. (3) The pressure gauge shows that the pressure is unstable. 1. There is leakage in the pipeline or the water outlet joint, and the sealing ring should be replaced 2. Leakage at the connection of the gauge rod, replace the sealing ring 3. The pressure gauge is damaged, repair the pressure gaugeSKU: n/a
There are no reviews yet.